ITD ::: Routing Information Protocol (RIP) Configuration
RouterA#show ip route
Gateway of last resort is not set
C 1.0.0.0/8 is directly connected, serial0/1
C 3.0.0.0/8 is directly connected, serial0/0
C 192.168.1.0/24 is directly connected, loopback0
Configure RIP on Router A
RouterA#configure terminal
RouterA#(config)#router rip
RouterA#(config-router)#network 3.0.0.0
RouterA#(config-router)#network 1.0.0.0
RouterA#(config-router)#network 192.168.1.0
RouterA#(config-router)#exit
RouterA#(config)#
Now verify these configuration on router A with command us under:
RouterA#show ip route
To check the routing protocol with this command.
RouterA#show ip protocols
RouterB#show ip route
Gateway of last resort is not set
C 1.0.0.0/8 is directly connected, serial0/1
C 2.0.0.0/8 is directly connected, serial0/0
C 192.168.1.0/24 is directly connected, loopback0
Configure RIP on Router B
RouterB#configure terminal
RouterB#(config)#router rip
RouterB#(config-router)#network 1.0.0.0
RouterB#(config-router)#network 2.0.0.0
RouterB#(config-router)#network 192.168.2.0
RouterB#(config-router)#exit
RouterB#(config)#
Now verify these configuration on router B with command us under:
RouterB#show ip route
RouterC#show ip route
Gateway of last resort is not set
C 2.0.0.0/8 is directly connected, serial1
C 3.0.0.0/8 is directly connected, serial0
C 192.168.3.0/24 is directly connected, loopback0
Configure RIP on Router C
RouterC#configure terminal
RouterC#(config)#router rip
RouterC#(config-router)#network 2.0.0.0
RouterC#(config-router)#network 3.0.0.0
RouterC#(config-router)#network 192.168.3.0
RouterC#(config-router)#exit
RouterC#(config)#
Now verify these configuration on router C with command us under:
RouterC#show ip route
0 comments:
Post a Comment